TCS Laser protection
Page 1 of 1
TCS Laser protection
Work perfomed by D. Le Galliot and R. Cavalieri.
This morning we implemented a laser overtemperature protection based on PLC for the TCS system.
In case the temperature of one of the two laser goes above 29 degrees, the laser is switched off and a red lamp is on.
The rearm of the laser is possible only by human action on a push button installed in the TCS room (labelled with "RESET").
The system is in parallel with the existing one based on ALP.
A test was made this morning (the laser was switched off simulating an increase of the TCS laser temperature).
This morning we implemented a laser overtemperature protection based on PLC for the TCS system.
In case the temperature of one of the two laser goes above 29 degrees, the laser is switched off and a red lamp is on.
The rearm of the laser is possible only by human action on a push button installed in the TCS room (labelled with "RESET").
The system is in parallel with the existing one based on ALP.
A test was made this morning (the laser was switched off simulating an increase of the TCS laser temperature).
Alessio- Posts : 127
Join date : 2008-11-07
Age : 52
Location : Rome
Similar topics
» Chiller and Laser
» First test on the new CO2 laser
» WI CO2 laser noise
» Laser temperature sensors fixed
» CO2 laser intensity stabilization installation
» First test on the new CO2 laser
» WI CO2 laser noise
» Laser temperature sensors fixed
» CO2 laser intensity stabilization installation
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|